Parting out two parts cars, one 2wd and one 4wd

Seanzy · Post by **Seanzy** » Thu Dec 11, 2014 6:41 pm

irowiki wrote:Do you by chance have a complete set of locks (with key) out of one of the cars? Ignition, doors, hatch.

Is it a FWD Hatchback or wagon?

I need:

complete distributor
radio cowl for FWD wagon/hatchback (plus screws)
plastic trim around bottom of steering column (can give pictures)
passenger side mirror (probably off the hatchback if that is what you have)
front windshield washer pump (or just the whole reservoir with pumps attached if in good shape
front passenger door outside handle (mine sticks)
front facing air vents ( all four I think, will check )

also looking for a cluster with tach in the 170k mile range

if the 4WD is an 83 or 84, the passenger side mirror (flexible one)

Ok, I did an inventory tonight and here is what I have...steering column trim, both pass side mirrors, front air vents(i have grey or tan...take your pick, of course the middle vents are black, front pass door handle and any internal components that you might need, lock cylinders w/ key(but like I said, the gas door doesn't work and the hatch sticks a little bit). I may also have a distributor and washer reservoir, but I'm gonna have to go through the cars. Both are packed full of extra parts. Also, what do you mean by the radio cowl?

Seanzy · Post by **Seanzy** » Thu Dec 11, 2014 6:45 pm

ARCHINSTL wrote:If it is a non-AC car, I'm up for the blanking plate that fills the spot where the AC condenser is normally fitted behind the grille.
I'm also looking for the undertray/panel that mounts from below the radiator back to the X-member.
I'm in St. Louis.
Thanks,
Tom M.

Sorry, that's a no go on the condenser filler panel. Both cars actually have AC. I do have the engine splash shield though.

Post by **ARCHINSTL** » Fri Dec 12, 2014 1:03 am

Thanks - see PM
Tom M.

4wdEconoBox · Post by **4wdEconoBox** » Thu Apr 23, 2015 5:37 pm

You don't happen to be willing to get rid of one of the engines do you? Mines burning a lot of oil and I need one I can build while I'm still driving the car haha.

JackWagon · Post by **JackWagon** » Fri Apr 24, 2015 3:01 pm

I am interested in a center console. Plastic tray and surround gear shift inbetween front seats. Also, the side access panel door in the back.

Gottolovem · Post by **Gottolovem** » Fri Apr 24, 2015 5:14 pm

I don't want to steal this thread from Seanzy!
But if he does not have what your asking for I do including a engine!

nugtown · Post by **nugtown** » Sat May 30, 2015 12:05 pm

Would it be possible to grab that 4wd transmission? How much? I have an 84 too, I live in Raleigh and drive to Boone quite often, so your location is not far off.

Janaka · Post by **Janaka** » Fri Jun 05, 2015 8:21 pm

Would you happen to still have a front strut assembly from either side of the 4wd? I just need the housing/tube that the strut cartridge fits in.

Gottolovem · Post by **Gottolovem** » Fri Jun 05, 2015 8:28 pm

I'm tierd of saying dont want to steel a thread so I'll start another.
I think this ones dead anyway

Tercel4WD.com

Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd

Re: Parting out two parts cars, one 2wd and one 4wd