transmission

[florykitty]

this is how i got this Tercel,I actually been burn with the guy that i purchase from but anyway i like the car so i end up pay the price

[Gottolovem]

Florykitty
I have the set of gears you are after already installed in the bell housing. I do not want to take the gears out because they were installed at the Toyota factory the way Toyota wanted.
If I sell you just the gears I don't know if the guy you have will install them properly.
THEY CAN'T JUST BOLT THEM there is a proper way to do it or they will where out prematurely.
So you can make me an offer on the entire thing.(bell housing with gears inside no transmission)

I took this entire transmission out of my personal everyday car when the 5th gear broke.
So I know there a good working set of gears (old but good).

This kind of gears usually out last the car there in if there is oil on them.

If you want just the gears perhaps another member has a set. I am only willing to sell the entire assembly.(bell housing with gears inside no transmission)

What do you think is a fair price including freight.

[florykitty]

let me know the price for entire assembly,let me know the freight for assembly and after that you tell me which way you want me send the monney to you monney order whatever you prefer and feel confortable,you decide if you want to hellp me,make me a reasonable price and like i sad i send the monney to you,and are you sure this is what i need

[florykitty]

also you recomand have the flywheel re-surfaced,i just have new front axle ,rear main engine seal ,gear oil,i try to think what else needs to be done since i have the transmission and front diff out
So i get all done once,

[florykitty]

Let me know gottolovem Thanks

[florykitty]

when i put this back together after i get the part from gottelevem ?
do i need new set of gasket?can i clean all up with non chlorine brake part cleaner?
please let me know what to buy,and how i am gon have this done step-step,so i dont have any future
problem with my tranny
Thanks Gottelevem,Thank you petros i want to do this ones and right
i purchase mobil 1 gear oir,rear main engine seal,i plan to resurfaced the fly wheel at machine shop,new front axles,new rack-pinion,ineer-outer tie rods import direct from o really,new shocks,new front brakes,ac charge and check i am sure there is more ,and i am gon end up with a paint job,i know never gon get this monney back but its a hobby and i like those 4wd Tercel,people call ugly boxes

[Gottolovem]

Yes you will need to (glue) the transmission and bell housing back together with non hardening gasket material.
Read this post the last portion of it is relevant to the job you need to do. SEE THE SPECIAL NOTE.
https://tercel4wd.com/forums/viewtopic.php? ... on+removal

[florykitty]

Gottolovem when i have this front diff replace with a good one,you think my problem is been solve ?
Based on the shop sad only that part is wrong ofcourse.
What actually front diff does?there is also rear diff on those cars,i understand been 4x4
is the rear diff that always has to match gear ratio 4-10 or other 3.73?
Thank you ,i hope get this think fix by spring

[Petros]

occasionally the differential ring and pinion just give up and get trashed like yours, thought it is not common. I have seen diff get trashed more often because someone put the wrong ratio in after a repair. The front and rear must match and some idiot interchangeability guides show all the years Tercel4wd trans are interchangeable, but they are not without swapping out the front or rear diff to make the ratios match. If you mismatch the front and rear diff ratio than you will either trash the front or rear diff or trash the transmission.

So you need to verify the diff ratio in the rear just to be safe before you get the car together. You have to jack up the car and put chalk marks on the wheel and drive shaft and turn the shaft by hand and count how many times it takes to turn the shaft to get one full revolution of the wheel. It will be either 3.73:1 or 4.1:1, so count carefully. You can also go ten revolutions of the wheel just to make sure you get etiher 37 or 41 turns of the shaft.

You need a differential in the car because when you go around a turn the outside wheel and the inside wheel have to make different size turns, so the outside wheel moves faster. the diff allows the axles to "differentiate" the speed of the inside and outside wheel/axle.

[Gottolovem]

If the shop is correct and the transmission is still good.
And the set of gears in the rear of the car is 4.1 (they likely are)
It would be smart to double check as Petros suggested.
Then I think you should have everything you need to put the car back together.

[florykitty]

Thanks much,gottolovem,Petros,Xirdneh for help advice etc,we have a good little Tercel comunity here,we help save those Tercel from those who Doesnt want fix it and take it to Pacyfic Recycling for $175 at least this much pay here for hope gone fix my little toy by summer,