well i have a little update not much but its a begining, and Carlos(tercel4wdrules) youll be getting a present soon
![Image](https://fbcdn-sphotos-a.akamaihd.net/hphotos-ak-ash4/262241_10150245528358291_820373290_7113185_2307121_n.jpg)
i did the begining of the machining in the lathe and started to do some modeling
here is the begining of the machining program, font was killing me so had to change it twice!
after a little convincing mastercam said ok and gave me this simulation
halfway through the drilling process
the begining of the lettering
finally the machining is done just the keyway is missing but that is just a half hour job
still looking for pistons and trying to decide if i knife edge the crank
tercel 4wd custom suspension, under drive pulley, vented brakes, cold air intake, and plenty more to come