I hope my GSP axles didn't come from this state of the art plant...
http://www.curezone.org/forums/am.asp?i=1063782
Chinese parts
-
splatterdog
- Highest Ranking Member
- Posts: 1624
- Joined: Sun Mar 26, 2006 10:26 am
- Location: Minnesota, USA
Re: Chinese parts
If they were made in the US...robots would do the work?
The building looks relatively new...at least the floor isn't grease soaked yet.
I have some jack stands where they apparently ran out of roll pins and just used sections of iron wire instead...sheared pretty quick.
But people in the US should feel good that so many are employed in China...at least that was the spin on the Nightly News before the economy tanked.
People in the US live in McMansions...drive big cars....have higher education....didn't you know?
The building looks relatively new...at least the floor isn't grease soaked yet.
I have some jack stands where they apparently ran out of roll pins and just used sections of iron wire instead...sheared pretty quick.
But people in the US should feel good that so many are employed in China...at least that was the spin on the Nightly News before the economy tanked.
People in the US live in McMansions...drive big cars....have higher education....didn't you know?
Give a boy a gun-give a biatch a cell phone-and pretty soon you almost got yourself a police state.
Orwell said: War is peace! Freedom is slavery. Ignorance is strength...
Orwell said: War is peace! Freedom is slavery. Ignorance is strength...