86 tercel at east bethel U-Pull (minnesota)

[shonuffisthemaster]

I'm going to look at it tomorow, not sure if its a 4wd but it says SW so I assume its a 4 door wagon. I need some parts, but I was wondering if I could pull anything for anyone else? I'll say if you get back to me before I go tomorow I'll charge twice the u-pull price (http://www.upullrparts.com/index.cfm/go/yard.prices), unless it is a real pain to get off, if you want me to go back later I'll have to see, its a 30 min drive each way but if I get enough requests I can split time / gas between them.

[CathodeRayTube]

i want the gauge cluster! assuming its the SR5 one that goes up to 110...and the single tiny triangle pice of SR5 trim on the drivers side front fender...

[shonuffisthemaster]

I'll see if its an sr5 and pull those for you if it is

[jimpomm]

I'm looking for one of the 4wd emblems that is on the rear hatch,easy part to pull.Thanks

[shonuffisthemaster]

I got that gauge cluster and trim, I'll PM you. jimpomm I'll pull that emblem next time I'm there.

So here is the deal if anyone wants me to pull anything for them.

its a beige 86 4wd sr5, no sunroof, its got a 130K engine and manual transmission, I assume there is something wrong with the engine if its in the junkyard, I might pull the transmission for myself. Its got worn and dirty non-plad beige SR5 seats that have no holes. DS front door is OK with some rust through on the inside, PS door not worth it, back doors are OK. All glass is in / good except the DS front window. hood pretty good with some rust on the front underside (not visible when hood cloased) its got a fairly minor bent part on the DS. bumpers are good. its got 3 (where did the other one go) totally 80's looking toyota alloy rims, there super square and make it look like a delorean (ok maybe not)

Like I said its an hour round trip and about a gallon of gas to get there, if I get enough requests I can split that cost up but lets call it $20 extra total. I think twice the U-pull price is reasonable but if its an easy pull like that emblem I'll just do 1 1/2 times the price, if its something harder to pull might be more, we'll discuss.

[ARCHINSTL]

I could use the tan DS and PS female seat belt holders - if intact and not cracked (mine are cracked at the top and work, but flop around). See this link for a pix: http://www.tercel4wd.com/forums/viewtop ... elt#p33239
Does it have a luggage cover?
Thanks,
Tom M.

[CathodeRayTube]

im also interested in mud flaps...but yes..PM me whenever you get the time. i have paypal etc...i do think that twice the u-pull price might be a bit much tho...id be happy to pay whatever it cost you as far as the part itself, your gas and the shipping, and maybe another $5 for the effort to pull it...i dont think the cluster is that hard to get out, it only took me like 10 mins.

[shonuffisthemaster]

ARCHINSTL I’ll check for those seat belts next time I’m there, it doesn’t have a luggage cover.

CathodeRayTube I finally sent that PM, sorry for the delay.

I don’t mean to sound like a dick guys but I’m not doing this for charity, twice the u-pull price + $20 split up between whoever wants parts next is it. I do handyman work and $40 is my minimum charge no matter how long it takes. I want you to get your parts and I like to help out fellow Tercel enthusiasts but it’s just not worth my time to pull, communicate, pack and ship for a few dollars. If you were a friend of mine and I was helping you out with your car it would be a different story.

[bassmasterchet]

Hi, I,m looking for a manual trans and maybe other parts for my 85 4wd tercel. I'm best on the phone. Thanks! 612-508-6400 Chet(whenever)