Cut an access hole ahead of stick shift

Talk about Forum Improvements or anything about the forums.
Post Reply
84Sr5wagon
Newbie
Posts: 2
Joined: Sun Jan 12, 2020 8:12 pm

Cut an access hole ahead of stick shift

Post by 84Sr5wagon »

Just wondering if anyone has ever cut an access hole ahead of the stick shift. This would be for maintenance, and accessing the verse idler plug. Figured I'd patch it up with sheet metal/sheet metal screws, and gasket compound.
Any thoughts?
User avatar
Petros
Highest Ranking Member
Posts: 11891
Joined: Sun Jan 28, 2007 6:31 pm
My tercel:: '84 Tercel4wd w/extensive mods
Location: Arlington WA USA

Re: Cut an access hole ahead of stick shift

Post by Petros »

I have never seen anyone do that, and there would be no reason to. access that plug is not too bad from the tunnel under the car if you just unbolt the rear cross member, and lower the rear of the trans (without removing anything else).
'87 Tercel 4wd SR5 (current engine swap project)
'84 Tercel 4wd (daily driver, with on going mods)
'92 Mazda MPV 4wd (wife's daily driver)
'85 Tercel 4wd DLX auto(daughter's daily driver)
'01 Honda Civic (other daughter's daily driver)
Post Reply