My car is a Toyota Tercel 1987 4WD 1452CC DX Wagon.
I did installed a new brake master pump.
When I disassemble the old one I didnt find any rubber washer at the connection of lines to the master pump.
When I install the new one, I did the same. I didnt put any washer.
Would it ok?
Can metal to metal connections prevent any leak?
Is it need to have rubber washers at the line- master pump connection
- Petros
- Highest Ranking Member
- Posts: 11933
- Joined: Sun Jan 28, 2007 6:31 pm
- My tercel:: '84 Tercel4wd w/extensive mods
- Location: Arlington WA USA
Re: Is it need to have rubber washers at the line- master pump connection
there are no washers or gaskets at the brake line connections. the conical shape of the flare hose nut makes all the seal it needs.
you are good to go.
you are good to go.
'87 Tercel 4wd SR5 (current engine swap project)
'84 Tercel 4wd (daily driver, with on going mods)
'92 Mazda MPV 4wd (wife's daily driver)
'85 Tercel 4wd DLX auto(daughter's daily driver)
'01 Honda Civic (other daughter's daily driver)
'84 Tercel 4wd (daily driver, with on going mods)
'92 Mazda MPV 4wd (wife's daily driver)
'85 Tercel 4wd DLX auto(daughter's daily driver)
'01 Honda Civic (other daughter's daily driver)
- Dumindu
- Top Notch Member
- Posts: 227
- Joined: Wed Aug 02, 2017 12:34 pm
- My tercel:: 1987 Toyota tercle 4wd DX Wagon 1452CC
- Location: Sri Lanka
- Contact:
Re: Is it need to have rubber washers at the line- master pump connection
Thank you very much.
Mr.Petros, You are doing a great service.
Mr.Petros, You are doing a great service.