CV axle continues to pop out

How-to's and repair secrets for your 4WD can be found here. Have a question? Ask it in here!
Post Reply
User avatar
Scott0911
Newbie
Posts: 3
Joined: Thu Oct 29, 2015 1:35 am
My tercel:: 1986 Toyota Tercel 4WD

CV axle continues to pop out

Post by Scott0911 » Sat Jul 06, 2019 11:40 pm

About two years ago I replaced the CV joints on my turdcell. 50 miles from home it snapped, part of it went into my tranny and destroyed my tranny.

This time I have replaced it two times now after about 20- 30 miles it clearly is starting to pop out again. I’ve replaced the snap rings with stronger ones, I’ve checked the length of the CV axle to make sure it’s the same. I don’t know what I’m doing at this point incorrectly. Please help me. I need a vehicle for work.
Love my 4WD wagon

xirdneh
Highest Ranking Member
Posts: 1963
Joined: Thu Aug 04, 2005 11:38 am
My tercel:: 87 tercel 4x4 wagon w/reringed engine, 83 tercel 4x4 wagon w/salvaged engine and 4.1 Diff's
Location: seabeck, washington, USA

Re: CV axle continues to pop out

Post by xirdneh » Sun Jul 07, 2019 1:39 pm

i wonder if there is something wrong with differential
Love those Tercell 4x4 wagons but they sure suffer from road noise.

User avatar
Petros
Highest Ranking Member
Posts: 11038
Joined: Sun Jan 28, 2007 6:31 pm
My tercel:: '84 Tercel4wd w/extensive mods
Location: Arlington WA USA

Re: CV axle continues to pop out

Post by Petros » Mon Jul 08, 2019 6:16 pm

I would pull off the front cover (drain it first of course), than use a wire brush and solvent to clean out the splines and snap ring groove. it may have sludge and build up in the groove not allow the snap ring to pop open all the way. You can buy different size round brushes at the auto parts store (they are cheap), use that to clean it out good with solvent, than inspect it with a flash light and see if there are any burrs or other defects, if so file them off with a round file, and clean with solvent and the brush again.

Usually that should do it. if the spine hub is badly worn or pitted, it may need to be replaced. thought that is rare, there should not be any relative motion between the male and female ends of the spline, so there should not be much wear. likely it is sludge build up that needs to be cleaned out.

good luck.
'87 Tercel 4wd SR5 (current engine swap project)
'84 Tercel 4wd (daily driver, with on going mods)
'92 Mazda MPV 4wd (wife's daily driver)
'85 Tercel 4wd DLX auto(daughter's daily driver)
'01 Honda Civic (other daughter's daily driver)

Post Reply