Not sure how many have installed an incline gauge / inclinometer in theirs but I just finished mine so I thought I'd put the info in if anyone was missing screws in the housing like mine was
The large screws holding the metal base onto the housing can be fit snugly with a #10 self piercing
The small face plate screws fit with a #4 self piercing, and I found brass #4S washers to put down in the little washer groove for the face plate
And the nuts for the back were M5 if I remember correctly
incline gauge build
-
- Top Notch Member
- Posts: 171
- Joined: Sun Nov 01, 2015 5:39 pm
- My tercel:: toyota
- Location: CA