incline gauge build

How-to's and repair secrets for your 4WD can be found here. Have a question? Ask it in here!
Post Reply
User avatar
Top Notch Member
Posts: 163
Joined: Sun Nov 01, 2015 5:39 pm
My tercel:: 1986 SR5 / 1987 SR5
Location: OKC

incline gauge build

Post by JDNightFox » Wed Feb 28, 2018 10:13 am

Not sure how many have installed an incline gauge / inclinometer in theirs but I just finished mine so I thought I'd put the info in if anyone was missing screws in the housing like mine was

The large screws holding the metal base onto the housing can be fit snugly with a #10 self piercing

The small face plate screws fit with a #4 self piercing, and I found brass #4S washers to put down in the little washer groove for the face plate

And the nuts for the back were M5 if I remember correctly

Post Reply