ISO: Trans Mount

Need a car part and don't know where to get it or how to install it. Look here!
Post Reply
Tman312
Newbie
Posts: 18
Joined: Tue Sep 13, 2016 7:06 pm
My tercel:: 1985 Tercel 4WD

ISO: Trans Mount

Post by Tman312 » Sat Nov 03, 2018 7:18 pm

Looking for a new or good condition manual 4wd transmission rubber mount

The only place I can find the correct part is Autozone, but they have since discontinued it.

Rockauto, Oreillys, etc claim they have it but it is an Auto mount.

OEM Part numbers appreciated too

User avatar
garyfish
Highest Ranking Member
Posts: 706
Joined: Sat Nov 19, 2005 4:22 pm
My tercel:: 1985 Tercel SR5, stock; 1987 T4WD DLX wagon, manual tranny
Location: North Coastal California

Re: ISO: Trans Mount

Post by garyfish » Sat Nov 03, 2018 11:38 pm

part # 12371-15070 ... No Longer Available (NLA) from any U.S. source, including all Toyota dealers, as far as can be determined

here's a recent relevant thread with good info:
viewtopic.php?f=2&t=13273
Last edited by garyfish on Sun Nov 04, 2018 1:41 pm, edited 1 time in total.
1985 Tercel SR5 4WD wagon, 300K
1987 Tercel DLX 4WD wagon, 6-speed manual, 248K -- got this one running Jan. 2015 (had been sitting for 2 years)

jimcrazy
Top Notch Member
Posts: 448
Joined: Thu Dec 08, 2011 6:33 pm
My tercel:: 1985 4wd 1986fwd 1983 4wd

Re: ISO: Trans Mount

Post by jimcrazy » Sun Nov 04, 2018 3:48 am

i use the fwd mount,just have to cut one side off the 4wd mount and weld it back on to the fwd mount.rockauto has the fwd mounts for like 10 bucks
You do not have the required permissions to view the files attached to this post.

jimcrazy
Top Notch Member
Posts: 448
Joined: Thu Dec 08, 2011 6:33 pm
My tercel:: 1985 4wd 1986fwd 1983 4wd

Re: ISO: Trans Mount

Post by jimcrazy » Sun Nov 04, 2018 3:52 am

more pics
You do not have the required permissions to view the files attached to this post.

User avatar
xirdneh
Highest Ranking Member
Posts: 1873
Joined: Thu Aug 04, 2005 11:38 am
My tercel:: 87 tercel 4x4 wagon w/reringed engine, 83 tercel 4x4 wagon w/salvaged engine and 4.1 Diff's
Location: seabeck, washington, USA

Re: ISO: Trans Mount

Post by xirdneh » Sun Nov 04, 2018 12:47 pm

Like
Love those Tercell 4x4 wagons but they sure suffer from road noise.

User avatar
Petros
Highest Ranking Member
Posts: 10327
Joined: Sun Jan 28, 2007 6:31 pm
My tercel:: '84 Tercel4wd w/extensive mods
Location: Arlington WA USA

Re: ISO: Trans Mount

Post by Petros » Mon Nov 05, 2018 4:08 pm

I likely have several of these rear mounts kicking around in a box somewhere, but they would be well used.

unless your old one is completely trashed, there is a fix I thought of for them if they have just sagged. clean it thoroughly, and and perhaps rough up the void places good with a small wire brush between the rubber mount. Than use wood wedges to get it back to the approx original position, install either RTV or polyurethane adhesive to fill in the void places between the rubber part of the mount. this should stiffen and strengthen the rear mount.
'87 Tercel 4wd SR5 (current engine swap project)
'84 Tercel 4wd (daily driver, with on going mods)
'92 Mazda MPV 4wd (wife's daily driver)
'85 Tercel 4wd DLX auto(daughter's daily driver)
'01 Honda Civic (other daughter's daily driver)

Tman312
Newbie
Posts: 18
Joined: Tue Sep 13, 2016 7:06 pm
My tercel:: 1985 Tercel 4WD

Re: ISO: Trans Mount

Post by Tman312 » Tue Nov 06, 2018 9:11 pm

Its so bad that my trans will move completely if I let the clutch out anybit too fast. Usually resulting in a clunk.

jimcrazy - I'll have to look into that, thanks for the info!

Post Reply