Tercel4WD.com

Spent the day sanding and preping plenum for paint,black for now, blue later. the reason I went with a custom built radiator is this engine runs 165 horse power 11 to 1 compression and the origional car that these engines come out of have a large capacity cooling system (my 3a had a severely milled ...

well for the last few days I've been wraping up loose ends,built a trany mount to drop trany 2" and carrier bearing. Welded a 3" piece of ex-pipe to mount air cleaner, this swap just fits close every where. Radiator fits nice,but original cooling fan wont fit due to increasing rad from 2 r...

Lil some how I over looked your post about the Pace Setter header,this looks like just what the doctor ordered !!! Thanks a bunch for the pix

Just finished wireing up c/o relay,when engine ignition is turned on ---- check engine light comes on ---- (sweet) when engine is cranked -- power to fuel pump (just ordered fuel line fittings and ss hose,pressure gague 2days ago) and spark from ig coil just like it should be. When I stop cranking g...

LilBeast my flywheel ended up weighing in at 11.6 pounds, total cost of project 40.oo flywheel inc freight,90.00 to turn down and install starter ring and step resurface ,50.00 to balance ,pretty reasonable.

Synth engine spacers are 2"x1/4" box tubing with the ends caped, engine mounts are stock (for now) this is getting close. Had to fab a recess in the rear of plenumn to allow clearence for the heater control valve (built a box 3x4 and welded it in) lots of little mods to get this in place, ...

So what did you do to drop this down? (cut coils? and how much) Looks great how does it handle on the highway and ride, Sweet

Home, great looking car nice tires and wheels, my 20v Black Top should be ready to fire up hopfuly next Looking at your ride makes me wish I'd have painted mine a diff color.

This is the nicest tercel I've ever seen. More pix PLEASE. WOW!!!!!!!!!!!!!!!! Larry.

Yes I'am let me know what shape it's in and how much Thanks Larry

Pix of plenum, neen to mod trany mount and drop carrier bearing down.

Synth just ordered a pace seter yesterday at least I can cut and weld as necessary, the flywheel cost 40 machine work 90, balance job 50, not bad all in all. started moding the air plenum for hood clearence,it will stock and drop the plenum down about 1 1/2 which works out just right. Thanks for you...

Flywheel machined down with 3ac starter ring pressed on and a corolla clutch,pressure plate balenced

Cap and rotor come off with ease for service,cant rember the last time I pulled a dizzy for service not a whole lot to go wrong! If you read the post a ways above you'd see i said I notched the seam.

Just got my OXB stainless header, realy doesent come close to fitting,hits the frame support that the lower control arm attaches to and the floor board, droped the trany with a floor jack to see if it would slip over head studs.No such deal nice looking piece,but on fit not even close REALY. Oh well...