Tercel4WD.com

Robert Walker has a series of Tercel mechanical repair videos on Youtube that are helpful. Here are some of the titles: ->Toyota Tercel 4WD Wagon 3a Engine Headgasket Removal ->Toyota Tercel 4WD Manual Tranny Disassemble in 20 minutes ->Toyota Tercel 4WD Replace Timing Belt, Front Seals & Water...

You're more than likely right. I added a can of restore in hopes to increase compression but I think the engine is too far gone to save. Oh boy. Thanks Chris.

Hey Bailey, Compression numbers point to a failed head gasket between 3/4 and that sounds more like a “knock” than a ping. The best check for “ping” or detonation would be to retard your timing some and see if it changes. I’ve never done a leak down test, but most say it is a better diagnostic eval...

Posting here in case anyone might know what the hell this knock could be. It only does it under load. It sounds like it's coming from the front of the head. I thought it was the rod bearings and just replaced them before filming this. My mechanic buddy told me is was ping due to bad gas. I drained t...

I really like this. I think I'll be picking one up too.

The Professor wrote: ↑Thu May 07, 2020 8:49 am Location?

Glenwood Springs, Colorado.

NWMO wrote: ↑Thu Mar 12, 2020 9:31 am Mike,

Welcome, great pics and story!!

Chris

The last time this man posted on this thread, I was graduating from high school.

Are these good for any parts other than what's on the motor? Grabbed a few things today off the motor. The corner lights or headlights any good for our cars? I took the fuel pump (looks after market), tvsv and the distributor with vac advance. It had the stock carb, all the a/c stuff, a good looking...

I'm thinking I just need to buy this ebay one for now then to get me by until I can find some poly bushings somewhere else. This looks like the correct one...

They did not. I just sent a message asking if they could offer any support.

Posting here as to not start a new thread: Where can I find the rack mount bushings? I've got some slop in the steering and seen firsthand thst my rack is moving before the wheels do. I remember the one bushing is a perfect circle and the other is more "D" shaped. I would like to find a se...

There's been one near me that pops up every now and again. Last I seen it was in 2 pieces and a bit of surface rust on some areas. The seller said it had been sitting in storage for several years. If it pops up again I will be sure to inquire about it for you

I couldn't tell you. I've always installed clutches with their prospective tools. I wouldn't want to chance it.

I've got one I could send you if you could send it back when you're done?

Amazing!