Tercel4WD.com

having kinda a problem finding parts ,this engine wasnt exported to north america ,Anyway wireing harness has a ben a pain theirs rubber gromet that seales it where it goes through fire wall clamped harness down with coper tubing clamps to keep it in place tomock it back to engine.works real well.

my computer is playing games so im goinging to post in short bursts,this is going fairly well the weather has been in mid 30striped car in driveway bought sheet of 1/2 '' plywood to mock up wireing harnes (ive taken a ton of pix that ill post when my conputer comes back from the hospital.

Anyway pulled allthe stuff out of the engine compartment . put a 1'' piece of flat as a shim under alt a/c pump (to clear front timing cover ,puled oil pan and scrayper needs to be cut and welded . scored a trany @crossmeber 150.00$ might need it

engine out mauked up alt p/s,alt need 1" spacer un der alt bracket maby shim under homnic bal SQ Engineering s-86.com water -thermostat conversion going to do COP and aplate. Gotta strip engine compartment so I capaint it.

Have you ever look at Club4ag.com losof great info some one found a adapter from a taxi cab meter that adeptes into your speedo cable 4ag claimes you need spd sensor to get ecu to work in closed loop. Need oil press light, temp gague ,a sence wire from starter to ecu? I just started my swap yester d...

Synth I'm sure by now your up to your but in aligators with the rewire job,a quick question how are you going to pick up a speed sensor signal for the ECU Larry.

I would respectaly disagre with highlanders post. think about this for a moment,during the power stroke the piston and rod assy (due to the elevated pressure in the combustion chamber) are pushing downward on the crankshaft,trying to push it through the lower main bearing caps. This is the reasion t...

I beleive this car is a Full Time 4x4 not shiftable out of four wheel drive. Larry:

Great post. The main question is how well is your reduced diameter flywheel (with a 3ac starter ring )holding up,no cracks? Did you doo any other mods to the flywheel ? What did the flywheel end up weighing ? Im just starting to instal a4age in my 1984 4x4 sr5 Tercel. What wireing harness,ecu did yo...

Great buy and Welcome.Lots of good folks hear and good info on these cars. About your oil leak the oil pressure sender which is on the block (behind and under the altinator, drivers side front) is a real common source of an oil ieak, the sending unit has one wire coming from it. good luck Nice Wheel...

Petros thanks for the comment. but color sanding and buffing this just about wore out my arms.Back to the 4age, I plan on getting a JDM engine rwd 130hp hopefuly. what would you recomend?

The project car is a 83, the green car I bought new in 84. thanks for looking.

Sorry for all the pix but i had to share with someone who would appreciate the project. Thanks for your patience,Larry: http://photobucket.com/Larrys-tercel-rebuild

Petros thanks for clearing this up for me. Larry:

I went to grage zeros web site to get a little more info about your car, but couldnt log on. I just finished building my 84 cr5 4x4, watched your video and I think Im hooked to do this mod. After reading through Synth post Im still a little confused about the clutch,pressure plate.flywheel set up. s...