Search found 11882 matches
- Wed Jul 19, 2023 11:41 pm
- Forum: Tercel 4WD Repair Questions
- Topic: fuel issue?
- Replies: 10
- Views: 6945
Re: fuel issue?
also, continuing research on sensors, i found some stuff about crankshaft position sensor and airflow sensor controlling the fuel pump does anyone know about sr5 fuel system sensors - existence/location FYI, these cars do not have crankshaft position sensor or airflow sensors. those are only on mod...
- Wed Jul 19, 2023 9:30 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Souping up a 3A Engine
- Replies: 20
- Views: 10067
Re: Souping up a 3A Engine
the 3a is not really suitable to getting more power out of it. I tried for years, and just kept blowing head gaskets because the head design sucks. the 8 tiny valves really limit its output, and the crappy water jacket design does not allow for even cooling in the head, more power causes it to warp ...
- Wed Jul 19, 2023 8:32 pm
- Forum: Tercel 4WD Repair Questions
- Topic: 1995 Tercel stalls at idle - 338,000 miles
- Replies: 5
- Views: 4691
Re: 1995 Tercel stalls at idle - 338,000 miles
do not ever go back to that dealership again, they are either grossly incompetent, or just crooks. none of those symptoms are related to bad rings. what idiots. The idle air control valve should have given a code, this was a common problem on the early OBD cars. My wife's Mazda gave that code, I tri...
- Wed Jul 19, 2023 8:11 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Oxygen sensor ?
- Replies: 8
- Views: 4925
Re: Oxygen sensor ?
I think if you can sort out the factory carburator, it is better than the weber. the daily driving is not so different, but the factory carb runs better at extreme temperatures: easier start and running when very cold, or very hot. the FSM has a series of simple tests for each system you should work...
- Wed Jul 19, 2023 7:32 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Decking my block - am I done?
- Replies: 3
- Views: 4618
Re: Decking my block - am I done?
nice work there. minor pitting is not ever an issue. most important is that it flat. that is why you need to use a large flat stone to get it flat. Get a steel straight edge and check it with a feeler gauge, factory spec is that you can not slide a .003" feeler gauge under it when pressed again...
- Wed Jul 19, 2023 7:25 pm
- Forum: Tercel Gallery and Projects
- Topic: Help! Looking for who built my 4age Tercel
- Replies: 9
- Views: 5614
Re: Help! Looking for who built my 4age Tercel
sounds like you got a great set up, doing a 4age swap is a big job with lots of details, and special cutom parts, to make it all work together. there is a 4age forum on line, I suggest you go join it and they can identify the exact year and car it came out of likely from the serial number stamped on...
Re: radiator
It arrived! It is all aluminum. Looks pretty good.
Re: radiator
My last “slow leak” was a tiny one one a heater core hose. I finally noticed it, but it took a while. I had one of those once too. it was a tiny pin hole leak, when it was warm it just shot a tiny stream of steam out and it was hard to notice it. when cold it did not leak at all. one day with the e...
- Thu May 18, 2023 9:21 pm
- Forum: General
- Topic: 84 Tercel Petros’ brake upgrade
- Replies: 11
- Views: 7985
Re: 84 Tercel Petros’ brake upgrade
I have bought a complete rear brake hardware kit, including the adjustors, for the 4wd wagon on Rockauto in the past. other on line parts suppliers may have them, try ebay motors perhaps. I would think the older, RWD corolla (about 1980?) should be the same part, because this is the same rear axle i...
- Thu May 18, 2023 9:15 pm
- Forum: General
- Topic: Setting Ignition Timing
- Replies: 12
- Views: 5961
Re: Setting Ignition Timing
cap off the vac lines at both ends if your vac advance will not hold a vaccum. also, check to make sure your mechanical advance is working. with the timing light watch what the timing does when you rev the engine, it should advance. if not, it is usually an easy fix, remove the distributor cap and g...
- Thu May 18, 2023 9:07 pm
- Forum: Repair Guides
- Topic: Effect Of Burned-out Charging Bulb
- Replies: 5
- Views: 4301
Re: Effect Of Burned-out Charging Bulb
quick alternator test: easiest at night, turn on the head lights with the engine off (pointing at a wall or garage door is best), than start the engine and observe the brightness of the head lights. they will get noticeably brighter as you rev up the engine. if it is not charging, there could be sev...
- Thu May 18, 2023 8:27 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Blown head gasket scenarios/ diagnosis
- Replies: 20
- Views: 8309
Re: Blown head gasket scenarios/ diagnosis
a compromised head gasket my not show up if you do a compression test. often it loses coolant so slowly it is difficult to tell if you are loosing it or not. best way to tell I have found is to remove the spark plugs and with a strong flash light, inspect the piston tops (rotate the engine so each o...
Re: radiator
I look forward to your report! If you’re pleased, I may buy one to put on the shelf for the future. yup, that is my plan. I don't need a radiator right now, I already have several spare used plastic/alum radiators in my parts inventory I got from PicknPull. But I want a good one that will last a lo...
Re: radiator
I just ordered the MHT 433813 from O'Reilly on line. got 20 percent off for mothers day too!
the picture showed the same plastic top and bottom tanks, but in the description it stated both the cooling fins and the head tanks are aluminum. hopefully that is what shows up.
the picture showed the same plastic top and bottom tanks, but in the description it stated both the cooling fins and the head tanks are aluminum. hopefully that is what shows up.
- Thu May 11, 2023 11:22 pm
- Forum: Tercel Gallery and Projects
- Topic: Hello From Calahoo!
- Replies: 53
- Views: 38426
Re: Hello From Calahoo!
you need to check the front suspension componets for too much play; the fact that is pulls to either side tells me there is something loose and sloppy. Not having power steering will cause that. Check the tie rod ends, ball joints, all bushings, steering rack and its mounting bushings, and the u-joi...