Tercel4WD.com

One more time

pix of dizzy ect

Petros: your thoughts about the header(20v has larger ex ports than 16v and a dif bolt pattern on the end studs) a pace setter header I could chop and weld the h ll out of. But revues say their a real cheep header,hows the obx header Synth gave you look for fit and quality. :?: Synth if your looking...

I've been looking at an OBX for a ae86 20v B/T swap on e-bay stainless, looked at numerous forums about this header only real complaint is it hits the floorboard under drivers feet (but I've droped the engine 2 inches so this should'nt be a problem, I hope,I realy don't have a convient way to weld s...

Your absoutly correct the strut towers are in the wrong holes, had it aligned and it steered great, glad you notised. This will need to be re-aligned after I get this running. Thanks. Did a little more wireing today, its comming right along

Lil what header are you planing on running,and have you had it instaled yet and how did it fit around the steering shaft( power or manual steering) looks good, a lot of work nice job Larry:

one more time 4age 20v B/T into a 1983 tercel sr5 4x4 fun but not plug and play (Thanks Synth and TOM advice to post) cranked it tonight has good oil pressure, starter engages nice and releases.Looks Great in the engine compartment questains welcome.

nice car BUT 5,000 You got to be kidding. To much oil money in South Dakota ,a sucker born every second.

synth: Looks like a compression test is in order (a broken ring?)

My two cents worth, most of the problem with these engines is getting an air lock in the head. when you fill the radiator remove the heater hose that points UP (i beleive its closest to driver on firewall the other hose points down)fill with coolant until it starts to run out of the heater pipe,inst...

Looking for a 110 mph speedo,I beleive 1986 and later (not real worried about the diff in gear ratio) pm me Larry

The propane thing is a fair idea untill you factor in you need to replace the ex valve seats with hardened stelite seats. When i sold Snap-on tools for a living (12 years) servised a account for Petrolane -propane dealer for western Montana ,if you dont it runs so hot and clean it pounds the valve s...

Interesting build ,if your looking for some REAL GOOD info on 4ag set ups the best out there is Club4ag . These guys know more about these engines than any one around especialy the ecu and timing set up,an unbelevable source of info. I'm about 3 weeks away from having my 1983 tercell sr5 4x4 up and ...

On my way home i was thinking about the trany in this car (no 5th gear)this could be the nylon bushing that sets into the shift lever that goes into shift linkage this is a piece when worn out realy causes a lot of slack in the shifter. also there are 2 pins in the shift tower that wear out and caus...

I'm going a half to give this person a call to check this out .