Search found 19 matches

by Shanemt
Wed Aug 28, 2019 7:03 pm
Forum: Tercel 4WD Parts: New and Used
Topic: Rear carburetor idle/throttle return spring
Replies: 4
Views: 1532

Re: Rear carburetor idle/throttle return spring

Also its not the throttle return spring, its for the fast idle on cold starts. The throttle return spring is much larger and stiff . It attaches to same place throttle cable connects and back to mount on head Thanks for the info. I’m still having a issue with is getting stuck open, and can’t seem t...
by Shanemt
Thu Aug 22, 2019 5:42 pm
Forum: Repair Guides
Topic: Carburetor disassemble and assemble video
Replies: 19
Views: 19936

Re: Carburetor disassemble and assemble video

Can anyone tell me where I can get one of these filters and the rubber tubes that connect it? Someone already answered your question in the other thread, but it's a one-way check valve. Can be replaced by a universal part. Thanks for the info! What about this spring that came from the back of the c...
by Shanemt
Thu Aug 22, 2019 5:36 pm
Forum: Tercel 4WD Parts: New and Used
Topic: Rear carburetor idle/throttle return spring
Replies: 4
Views: 1532

Rear carburetor idle/throttle return spring

My car starts fine, but when I rev it up the butterfly valve is getting stuck open from what looks to be a loose spring on the back of the carb. I took it apart and tried to tighten it but didn’t seem to help much. Here is a picture of what I think the problem is. Appears to be the throttle return s...
by Shanemt
Fri Aug 16, 2019 11:30 pm
Forum: Part Numbers - OE and Aftermarket
Topic: Engine main wire/oil pressure wire connector
Replies: 2
Views: 6814

Re: Engine main wire/oil pressure wire connector

You may be able to fish out the rubber isolator on top of that connector and solder a new wire to the remaining strands. I've had to make a repair once like that, might have been on the same plug even. Thanks for the advice I was able to get it connector all taken apart without damaging it, and thi...
by Shanemt
Fri Aug 16, 2019 6:05 pm
Forum: Part Numbers - OE and Aftermarket
Topic: ISO carburetor choke breaker diaphragm filter and hoses
Replies: 1
Views: 7029

ISO carburetor choke breaker diaphragm filter and hoses

This like plastic piece broke when I touched it on the back drivers side of the carburetor, and appears to be the choke breaker diaphragm filter. It says aisin 3a27 on it. I’d like to replace the hoses too, but I could also probably reuse them. Any help is much appreciated!
by Shanemt
Fri Aug 16, 2019 5:57 pm
Forum: Part Numbers - OE and Aftermarket
Topic: Engine main wire/oil pressure wire connector
Replies: 2
Views: 6814

Engine main wire/oil pressure wire connector

Looking for an engine main wire/ oil pressure wire connector and possibly oil pressure s/w too. Parts E and 41 in the diagram picture. Any help would be appreciated!
by Shanemt
Fri Aug 16, 2019 5:20 pm
Forum: Repair Guides
Topic: Carburetor disassemble and assemble video
Replies: 19
Views: 19936

Re: Carburetor disassemble and assemble video

Can anyone tell me where I can get one of these filters and the rubber tubes that connect it? Came off the choke break diaphragm on the back drivers side of the carburetor. It crumbled when I touched it.
by Shanemt
Fri Aug 16, 2019 3:58 pm
Forum: Tercel 4WD Parts: New and Used
Topic: ISO front differential with mounts for 83-84
Replies: 15
Views: 3329

Re: ISO front differential with mounts for 83-84

you need to number the pictures, too many to address with clairity. but those bolts: small ones look like oil pan bolts (should be 10mm), or used to hold on sheet metal parts or brakets. the short one with the round washer looks like the one that hold the heater tube to the bell housine where it co...
by Shanemt
Thu Aug 15, 2019 2:29 pm
Forum: Tercel 4WD Parts: New and Used
Topic: ISO front differential with mounts for 83-84
Replies: 15
Views: 3329

Re: ISO front differential with mounts for 83-84

493F9245-CE6B-40DF-BB77-3E34B99FB47E.jpeg Here’s an update on the progress with my Tercel project. Sorry it took a minute to respond I’ve been busy working and such. I was able to find a replacement Z52F, and dropped the old one out. You guys were right and the whole output shaft from the transmiss...
by Shanemt
Wed Jul 24, 2019 10:05 am
Forum: Tercel 4WD Parts: New and Used
Topic: ISO front differential with mounts for 83-84
Replies: 15
Views: 3329

Re: ISO front differential with mounts for 83-84

wow, someone really was hard on that one. you should go ahead and drop the whole trans. the front diff is integral with the bellhousing on the front of the trans, and the whole case will likely be full of ground up metal. it should get opened up and everything flushed out good. get a front diff ass...
by Shanemt
Wed Jul 24, 2019 10:00 am
Forum: Tercel 4WD Parts: New and Used
Topic: ISO front differential with mounts for 83-84
Replies: 15
Views: 3329

Re: ISO front differential with mounts for 83-84

Nice looking rig Shane, I would expect the roof racks were added later, possibly by a dealer, but not likely. There were a few variations of roof racks that were likely production, but they all bolted through the roof. Nice car, love the seats. My project car is an 83’ with the brown (like your blu...
by Shanemt
Wed Jul 24, 2019 9:52 am
Forum: Tercel 4WD Parts: New and Used
Topic: T4WD carbs/instrument clusters/3A engine/trans
Replies: 19
Views: 8197

Re: T4WD carbs/instrument clusters/3A engine/trans

tercel4wdrules wrote: Wed Jul 24, 2019 9:08 am
Shanemt wrote: Tue Jul 23, 2019 12:42 pm I need a front transaxle for a Z52F!
You need the front diff/bellhousing?
Ya I think my bellhousing is still good just really need all the gears, mounts, and axles is what I’m looking for.
by Shanemt
Tue Jul 23, 2019 10:30 pm
Forum: Tercel 4WD Parts: New and Used
Topic: T4WD carbs/instrument clusters/3A engine/trans
Replies: 19
Views: 8197

Re: T4WD carbs/instrument clusters/3A engine/trans

Do you have a good, working distributor for sale? Those are as rare as hen’s teeth... unfortunately, I don’t anymore. I have found a few in parts cars just not one I’ve actually been able to convince someone to remove and sell me. I think I got it figured out it’s just going to cost me about the sa...
by Shanemt
Tue Jul 23, 2019 8:20 pm
Forum: Tercel 4WD Parts: New and Used
Topic: ISO front differential with mounts for 83-84
Replies: 15
Views: 3329

Re: ISO front differential with mounts for 83-84

This is my Tercel by the way it’s super clean inside and out except for the differential being blown to pieces. I paid $500 for it the $300 to rent a uhaul car transport trailer to tow it home from Oregon. It came with 2 new seats to replace the torn front seats, and is the only one I’ve ever seen w...
by Shanemt
Tue Jul 23, 2019 6:21 pm
Forum: Tercel 4WD Parts: New and Used
Topic: Free ‘83 sr5 parts car in South Lake Tahoe
Replies: 2
Views: 954

Re: Free ‘83 sr5 parts car in South Lake Tahoe

I agree I need the front transaxle ha!