Tercel4WD.com

Thanks Tercle for that link! I really like the audible alarm idea and the super quick install. I wonder how reliable a surface temp sending unit would be in a water-cooled application though. I already purchased another set-up... I found a cheapie gauge with a built-in adjustable dummy light (unfort...

Petros, Thanks for the ideas! I like the fan switch idea, though a separate overheat light would be ideal. I just saw your post and haven't check around for those aftermarket set ups you mentioned. I know I've seen the sender units for the aftermarket gauges, but all that stuff seems to be for race ...

I am just finishing install of a rebuilt 3A-C, plus lots of new parts...hoping the tercel to last another many miles. This all after the sad premature death of the original perfectly-running, no-oil-burning engine at only 265k miles due to the radiator fan not kicking on at idle. It was -15F at the ...

Helipilot77, i bought an entire clutch kit...it came with everything EXCEPT the pin! I then checked rockauto, auto stores, amazon, ebay, the dealership...all "discontinued" or unavailable or unlisted. So...I bought one for a Mitsubishi that looked similar to the diagram in the book. Defini...

Hi. I know this thread is super old, but I am swapping engines and noticed that my throughout bearing retainer clip is missing! It seemed to run/shift fine without it, if indeed it has been missing all along since last clutch job. Foryst...did you end up running without the clip, or did you find one...

Hey there everyone! Does anyone have a manual steering shaft from '83/'84 (without the tilt)? I too am gathering parts for the swap to manual power steering. Currently after PS pump failure, I have been driving with the belt disconnected and getting 2 mpg improvement! The minimal extra effort to ste...