Search found 2120 matches

by xirdneh
Fri Aug 19, 2022 10:01 am
Forum: Tercel 4WD Repair Questions
Topic: HAI Hose
Replies: 2
Views: 375

Re: HAI Hose

Make sure the three ports at vac adv are hooked up correctly. The HIC port has a pinhole. Usually its on top passenger side but i have seen it on top drivers side once
by xirdneh
Fri Aug 19, 2022 9:59 am
Forum: Tercel 4WD Repair Questions
Topic: Stock vs. Weber
Replies: 31
Views: 3820

Re: Stock vs. Weber

I have tried the weber and went back to stock. Mostly for mpg reasons
by xirdneh
Fri Aug 19, 2022 9:57 am
Forum: Tercel 4WD Repair Questions
Topic: New to me Tercel rundown
Replies: 25
Views: 3205

Re: New to me Tercel rundown

Between exh and intake manifolds a homemade copper gasket should work
by xirdneh
Fri Aug 19, 2022 9:47 am
Forum: Tercel 4WD Repair Questions
Topic: Tercel 4wd Transmission Input shaft gears are broken...
Replies: 5
Views: 700

Re: Tercel 4wd Transmission Input shaft gears are broken...

How much oil was in the tranny? 4 quarts is full, less than two is bad. Usually there are signs of running hot like blackend or browned gears/ shafts. If no signs of low oil/heat i would save the synchros that are not worn to no gap. And fifth gears if they are not chipped. Not much else is worth sa...
by xirdneh
Fri Aug 19, 2022 9:40 am
Forum: Tercel 4WD Repair Questions
Topic: clutch, clutch cable, and adjuster questions
Replies: 5
Views: 555

Re: clutch, clutch cable, and adjuster questions

I am betting clutch disc is worn
by xirdneh
Fri Jul 08, 2022 8:38 pm
Forum: Repair Guides
Topic: Horn repair
Replies: 9
Views: 11671

Re: Horn repair

I made a brass part to slip over the brush to make it longer. Then lube with dielectric grease
by xirdneh
Fri Jul 08, 2022 8:30 pm
Forum: Tercel 4WD Repair Questions
Topic: 1985 Toyota Tercel 4WD SR5 6-spd seals?
Replies: 11
Views: 1126

Re: 1985 Toyota Tercel 4WD SR5 6-spd seals?

24. Seal for Extension Housing Shift Shaft hole, Toyota Part # 90311-18013 is 8mm Thk, Timken 1015N does work but its 6mm Thk, Napa 6610 is 7mm thk. Hole in tranny 1.099” OD, shaft dia .709”18mm. Seal .6595” ID x 1.111” OD x .319” thk. Colonial Seal size A 18x28x8. (Updated 12-22-15)[/b 25. Output S...
by xirdneh
Fri Jul 01, 2022 6:21 pm
Forum: Tercel 4WD Repair Questions
Topic: No. 5 clutch hub assembly remove/replace
Replies: 3
Views: 439

Re: No. 3 clutch hub assembly remove/replace

If so i pull using simple puller and install using large deep type socket and knock it on with hammer. Have to make sure synchro notch stays lined up and dont forget to have shift fork hooked up. I do not know how many times I forgot the shift fork
by xirdneh
Fri Jul 01, 2022 6:17 pm
Forum: Tercel 4WD Repair Questions
Topic: No. 5 clutch hub assembly remove/replace
Replies: 3
Views: 439

Re: No. 3 clutch hub assembly remove/replace

Did you get this done. I assume your refering to 5th gear assy on front driver side of tranny.
I do not have FsM handy
by xirdneh
Fri Jul 01, 2022 6:14 pm
Forum: Tercel 4WD Repair Questions
Topic: Distributor vacuum lines
Replies: 9
Views: 3078

Re: Distributor vacuum lines

The High altitude port on vac adv unit is the one with pin hole.
by xirdneh
Tue Apr 19, 2022 10:41 pm
Forum: Tercel 4WD Repair Questions
Topic: Oh boy, valve knock? Video inside
Replies: 40
Views: 4374

Re: Oh boy, valve knock? Video inside

Skirt may have fallen off piston #3 or 4 and is burning oil because cylinder is now scored. Or piston is cracked, but that usually does not cause loss of oil, and knocking quiets down when engine warms up. Broken wrist pin will score cylinder too. I have had all three happen. Skirt falling off has h...
by xirdneh
Fri Jan 28, 2022 10:31 am
Forum: General
Topic: diagnosing high idle
Replies: 24
Views: 4663

Re: diagnosing high idle

I have had several carbs with the butterfly hanging up. It gets worn out on one side . If you disconnect throttle cable and start the engine and work throttle gently letting it back down to idle. If idle is high see if a light push down on linkage brings it to lower idle. If so it could be the butte...
by xirdneh
Mon Jan 10, 2022 10:37 pm
Forum: Part Numbers - OE and Aftermarket
Topic: Top of tranny shifter boot
Replies: 3
Views: 4361

Re: Top of tranny shifter boot

I have used the boot on several trannys . I have no info on how long they last
by xirdneh
Sun Jan 09, 2022 7:01 pm
Forum: Part Numbers - OE and Aftermarket
Topic: Top of tranny shifter boot
Replies: 3
Views: 4361

Top of tranny shifter boot

8134064
Crown J8134064
Rugged Ridge 8134064 (18885.3)
Originally for Jeep T4 (81-88)