Tercel4WD.com

After six plus years of searching for everything t4 in northern Nevada. I walk into pick&pull today there it is a 1988 t4 and yes the elusive cup holders do exist.

sounds like the fifth gear has given up the ghost. could be a linkage issue, but that seems unlikly. I will be likely be hauling some very used transmissions up from California, you are welcome to one of them if you want it for parts. Petros if you are going through Reno to pickup those trannys I c...

I tried to find a import engine earlier this year found nothing. I did however find a place in chico ca. Rising sun engines they found me a used runner they bench test all engines they sell and warranty for 6 months. The price was 450 or 495 I think so I bought one from them installed it fired right...

Runs like a champ again. I dropped the tank and the fuel pickup screen was full of chunks of rust from blowing the line out backwards six months ago.I am amazed it has driven around for the last six months withought issue WOW. Got another screen at pick&pull and changed all fuel lines. So happy ...

So today I bypassed the fuel tank with small gas can and the car drove around fine. The fuel filter is rather new and the fuel pump is also only a couple months old. I put a new filter on and hooked up the gas tank. This time the car ran for almost a half hr before starting to stall out I popped the...

So it's not on the electric side it has to be fuel. Car runs fine until it comes up to temp then starts to cut out and will only idle. The car revs up just fine when I spray starter fluid down its throat. I know the carb is good and getting fuel but it's starving when engine is hot.

So far i have changed out dizzy,plug wires, entire carb, alternator, and relays with known good ones off another running car. The plugs are just about all that's left on the electrical side and i will do those when i get home.

Still no luck changed out the dizzy and still cuts out when under load. Pulled fuel line off and turned over plenty of fuel.

The plow doesn't really have a way to adjust the height there is a chain to hold it up when not in use or it sits on the ground with little skid plates to prevent the blade from digging in to the ground. It does detach from the bumper i will try to post more pics on how it was mounted soon but the c...

photo of snow plow for the member that wanted to see it

I do have another dizzy I will give it a try tommrow it does have one less vac line on it though. I hate to mess with vac stuff on these t4s. Thanks for the suggestion

Today I gave a short tow to a woman out of gas just a hundred feet or so. After I left her at the gas station I noticed that my idle started to surge up and down. Ten miles down the road the car started to cut out all together and die. After calling a friend to tow me back home I found a couple of b...

Thanks for the advice i will add the holes buy the exaust valves and proceed with the job. If you are ever in the northern nevada area or any other member for that mater feel free to contact me. Burning man perhaps i have a large group of Canadian burners that store there stuff on my property and us...

Petros the new gasket in the photo is fel-pro however the 4 holes directly across from the combustion chambers are off center they do not mate up to the holes in the head. Could it be a mistake from the fel-pro factory or are they all that way will i harm the gasket buy drilling the holes in the rig...

I just went to quadruple check and the new gasket matches the picture in petros's method exactly
the old gasket has a hole above every single orifice in the block innermost outermost all of them