Search found 5 matches
- Tue May 16, 2017 8:35 am
- Forum: Tercel 4WD Repair Questions
- Topic: Tercel input shaft bearing replacement
- Replies: 15
- Views: 5764
Re: Tercel input shaft bearing replacement
Ok so new development on the transmission, just lost all forward gears but I still have reverse. It shifts into all forward gears but no movement, and the bearing noise I had before is even worse. What could it be now? Currently the tercel is in my shop and we almost have the transmission dropped bu...
- Fri Apr 28, 2017 8:20 am
- Forum: Tercel 4WD Repair Questions
- Topic: Tercel input shaft bearing replacement
- Replies: 15
- Views: 5764
Re: Tercel input shaft bearing replacement
Thanks Xirdneh, my buddy and I are swapping a 6.9L deisel IDI into his bronco A.T.M, but after that we are dropping the trans and figuring it out might just swap every thing out... we shall see
- Thu Apr 27, 2017 8:34 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Tercel input shaft bearing replacement
- Replies: 15
- Views: 5764
Re: Tercel input shaft bearing replacement
The 88 parts rig supposedly has a brand new clutch so I can pull that pilot out and check and see if that's my noise, im going to do a fluid change in the tranny aswell. Tomorrow im changing out the rear shoes and passenger side wheel cylinder, it leaked out all of my break fluid so bleeding the bre...
- Thu Apr 27, 2017 3:43 pm
- Forum: Tercel 4WD Repair Questions
- Topic: Tercel input shaft bearing replacement
- Replies: 15
- Views: 5764
Re: Tercel input shaft bearing replacement
"They all have a recess cut around one outside edge (53mm dia) and it is used for a retainer (12mm bolt and small plate) to lock bearing in place. The 14mm Thk bearing protrudes aft far enough for the large Idler Gear to make contact and that is probably why the 13mm Thk bearing is used. The Id...
- Thu Apr 27, 2017 10:23 am
- Forum: Tercel 4WD Repair Questions
- Topic: Tercel input shaft bearing replacement
- Replies: 15
- Views: 5764
Tercel input shaft bearing replacement
So I've tried searching but found nothing, anyways my 6speed transmission on my 83 makes a noise in neutral with the clutch disengaged and in every gear, engage the clutch in neutral and the noise stops. Was reading around and read that is could be the input shaft bearing, so I've found part number ...